Garage door safety checklist for Westport homeowners

Five minutes a month keeps most garage doors safe. Print this page, keep it in the garage, and feel free to share or link to it.

Call (475) 889-7986

You don't need tools for any of this. The point is to catch a worn cable, a weak sensor or a door that no longer reverses before it turns into a stuck car or an injury.

What Westport homes are up against

Westport has more river and Sound frontage than almost any town in Connecticut, and that shapes what a garage door goes through. Around Compo Beach, Saugatuck Shores and Old Mill, salt air settles on springs, cables and hinges all year. Look at the cables where they wrap near the bottom brackets once a month. Fraying or rust there is the early warning, and it is a job for a technician because those parts are under full spring tension.

Further inland, in Coleytown and Old Hill, the issue is trees and long winters. Leaves pack into the tracks in fall, and a bottom seal can freeze to the slab after a wet night. If the door will not lift on a cold morning, do not keep pressing the button. Free the seal by hand first, or the opener may strip a gear or pull the top section out of line.

Every month

  • Reverse test: lay a roll of paper towels flat under the door and close it. The door should touch it and go back up. If it doesn't, stop using the opener until it's adjusted.
  • Look at the cables on both sides at the bottom corners. Frayed strands or rust are a reason to call, not to keep using the door.
  • Photo-eye test: start closing the door and wave a broom handle through the beam near the floor. The door should stop and reverse.
  • Watch it run: the door should travel smoothly and evenly. A jerk, a pause or one side lagging behind the other is worth a closer look.
  • Balance check: pull the red release cord with the door closed and lift it by hand to waist height. A balanced door stays put; one that drops or shoots up has a spring problem.

Before winter

  • Put a battery in the opener's backup if it has one; winter storms are when power cuts strand cars.
  • Check the rubber seal along the bottom of the door. If you see daylight underneath, a new seal keeps out snow, water and mice.
  • Clear leaves and grit from the bottom of the tracks so rollers don't bind when it gets cold.
  • Clean the photo-eye lenses; condensation and grime are a common cause of doors that refuse to close.

During cold weather

  • If the door is frozen to the ground, don't keep pressing the button. Free the seal gently with a plastic scraper or warm (not boiling) water, then try again.
  • Sweep slush and road salt away from the threshold; salt water rusts the bottom of the tracks and the door.
  • Keep the area under the door clear of ice ridges so the door can seal and the reverse system isn't fooled.

Spring and summer

  • Wash the door and check painted wood or steel for peeling and rust spots before they spread.
  • Test the reverse and photo-eye again after any work on the door or opener.
  • Check that weatherstripping along the sides hasn't dried out or cracked in the heat.

Stop using the door and call if

  • A loud bang, then a door that won't lift: a spring has broken.
  • A cable hanging loose or a door hanging crooked.
  • A roller out of its track or a door stuck partway.
  • The door fails the reverse test.
  • Visible gaps or cracks in a spring.

Never

  • Never adjust, loosen or remove springs, cables or the bottom brackets yourself; they hold the door's full weight under tension.
  • Never walk or let children run under a moving door.
  • Never keep using the opener on a door that's crooked or heavy; it will strip the gears or pull the door off its track.

Door stuck? Call before you try to force it.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (475) 889-7986
Call (475) 889-7986