Garage door won't close: sensor repair in Westport

A garage door that refuses to close is annoying, but it is the safety system doing its job.

Call (475) 889-7986

In short

If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Westport realigns or replaces the sensors and tests the safety reverse.

Ceiling opener and torsion spring over a single garage door

Doors that won't close in Westport

Around Compo Beach, Compo South and Saugatuck Shores, salt air and the occasional coastal flood are hard on sensors, and corroded connections make the lights drop out when it is damp. In Greens Farms and Long Lots, large homes have three or four doors, and the bay used for bikes and beach gear is the one that gets blocked. Coleytown and Old Hill are wooded, with leaves in the doorway from October. In Saugatuck and downtown, older garages are narrow. A door that only refuses to close late in the day is looking into the low sun.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

Quick things to rule out

  • Is anything in the path of the beam, even a leaf or a cobweb?
  • Are both sensor lights lit and steady?
  • Does the problem only happen at one time of day? That points to sun in the sensor.
  • Is the wall control's lock or vacation button switched on? It disables the remotes.

Anything beyond that, including limit and force adjustment, is a job for a technician, because a wrong setting can stop the door from reversing when it should.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Westport

  • Compo and Compo South: Around Compo Beach and down toward the Sound. Expect salt-air wear on springs and hardware.
  • Saugatuck and Saugatuck Shores: Near the train station and the mouth of the Saugatuck River, with waterfront homes and older houses on smaller lots.

See the full Westport service area.

Door stuck? Call before you try to force it.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (475) 889-7986
Call (475) 889-7986